gsl-firmware in rpm/deb for Jumper EZpad 6 Pro
Fork

Source Tree

Item	Description
Manufacturer	The name of the device manufacturer
Device	The full name of the device, including a version or product code if there are multiple revisions
Website	http://.../products/device
Vendor driver (Windows)	ftp://.../drivers/device/driver.zip
Extracted firmware	firmware.fw
Firmware for gslx680-acpi	silead_ts.fw
Display resolution	The resolution of the display, such as 1920x1200
Touch panel resolution	The resolution of the touch screen, usually smaller than the display resolution
Touch controller	GSLxxxx, you should open your device and verify this
Multitouch support	Yes (number of recognized touch points) or No if unsupported. All Silead chips should support 5 or 10 touch points.
Finger tracking	Yes, if the chip already does finger tracking, No if software finger tracking needs to be enabled in the driver
Mirrored horizontally	Yes, if the touch screen is mirrored along the X axis, i.e. left and right are reversed, otherwise No
Mirrored vertically	Yes, if the touch screen is mirrored along the Y axis, i.e. top and bottom are reversed, otherwise No
Axes swapped	Yes, if the touch screen is rotated by 90 degrees, i.e. moving from left to right results in movement from top to bottom
Comments	The exact fwtool command line used to generate silead_ts.fw or other relevant information

Nome	Tamanho	Rev.	Hora	Autor	Mensagem de Log
4good
chuwi
cube
dexp
digma
eastrising
edugear
ilife
insignia
jumper
lark
linux
multilaser
myria
nuvision
odys
onda
proworx
rca
schneider
techbite
teclast
trekstor
unsorted
utok
vinga
voyo
README.md.template	1.7 k	870af4d	2016-03-25 00:49:43	Gregor Riepl	Increased indentation of readme templ...